||What's in the Box
||USB Current Monitor And Voltage Detector Power Meter Tester & Measure
||Product Size (L x W x H) (CM)
||5.8 x 2.85 x 1.5
||1 x USB Detector
||Net Weight (KG)
USB Current Monitor And Voltage Detector Power Meter Tester & Measure
What is the function for this device?
It can use to :
- Measure the current accuracy of your power bank (mAH).
- Detect your current (Volt and Amp) supply by your USB Port, Socket or Power Bank
- Help you to diagnose low quality cable (Low quality cable has higher resistance which can lead to lower voltage/current transmission)
- Help you to identified your performance of your power bank
- To diagnose the current charging on your USB device
- Assists you to find out the best combination of USB cable and Power source
This item can be a USB charging current, voltage, discharge capacity, intelligent devices. It can be very easy to test and find digital device charging problem.
Tester three dimensional size 58 * 28.5 * 15mm (without cable), about 16 cm length of the line. The only button on the tester is used to view and test data switch, the tester can store 10 groups of test data.
USB output port can be connected to a data line, a discharge resistor or the like cable device comprising a data communication function, the data does not affect the data transmission line. Test specifications, voltage can not exceed 7V, current can not exceed 3.5A.
Note: When the voltage is lower than 4.7V on the instrument display or higher than 5.3V, the LCD screen will flash, Does not affect the use.
Here is a example for 3A: When you set electonic load at 3A model, the current will be adjusted step by step. It will cost you about 10 seconds and you can see the result changing procedure in the LCD screen. When you see the 3A result shown in LCD screen, the adjustment process is finished. You can shut off the electronic load and the parameters will be saved automatically.
Clean the data: Push the button until the parameters changed to next sets of parameters. Then release the button. Then the next sets of parameters will be started and they will start from zero.
Check the parameters: Push the button (quickly) twice , then it is checking model. The LED background will be flash.Then you can see the next set of parameters in LCD screen. Push the button twice again, you release the parameters checking model. LED backgroud be be light with flash.
Over voltage or under voltage: An arrowhead will be shown in LCD screen and LED background will flash. Push the button and LED will be light without flash. It will last 30s.
Turn on model: The LCD screen will show all parameters within 1s when you connet power supply by MicroUSB or male plug of USB with wire (It is to check whether the LCD screen is good or not). Then you can see the parameters used last time (capacitor and which set of parameters). You also can see the current voltage, current and over voltage or under voltage.
Input : 3-7V/50mA~3500mA
Onput : 3-7V/50mA~3500mA
Capacity : 0~19999mAh
Communication function : Yes
Parameters adjusting fuction : Yes
Equipments for parameters adjustment : One electronic load, one constant current source.
Parameters that you can test : Voltage of battery, current of battery, value of discharging capacitor.(Total ten parameters)
* The LCD screen is protected by a thin layer of plastic. You may remove it when you start use.