Operating voltage: 3.6V - 6V
Module type: Master of salve
- The core module from the module using the HC-06 , leads interface includes VCC, GND, TXD, RXD, aside LED status output pin , the microcontroller can be connected via Bluetooth to determine whether the pin state , KEY pin on the slave invalid
- Led indicate Bluetooth connection status , flashes to indicate there is no Bluetooth connection , Steady Bluetooth port is connected and turned on
- Bottom 3.3V LDO, the input voltage 3.6 ~ 6V, when unpaired current of about 30mA, the pairing of about 10mA, the input voltage must not exceed 7V!
- The interface level is 3.3V, you can directly connect a variety of SCM (51, AVR, PIC, ARM, MSP430 , etc. ), 5V microcontroller can also be connected directly , not through without MAX232 MAX232!
- Open to 10 meters effective distance of over 10 meters are possible, but do not make this connection to ensure the quality of distance
- After the pair when using full-duplex serial port , without having to know any Bluetooth protocol, but only supports 8 data bits, 1 stop bit , no parity communication format , which is the most common communication format , not support other formats .
- Establish a Bluetooth connection when not support setting the baud rate , the name , the pairing password via AT commands , parameter set -down to save . After Bluetooth connection is automatically switched to transparent mode
- Small size (3.57cm * 1.52cm), chip production plant to ensure the quality of the patch . And set transparent shrink tube , dust and beautiful, and there is some anti-static capabilities.
- The link from the machine, computer , Bluetooth with Bluetooth from a host with a variety of functions , most Bluetooth phones , PDA, PSP and other intelligent terminal pairing between slaves can not be paired .
TXD: the sending end , generally expressed as their transmitter, normal communication must be connected to RXD another device .
RXD: the receiving end, generally expressed as their receiving end, the normal communication TXD must be connected to another device.
Itself when normal communication TXD RXD devices connected forever !
Collected spontaneously : RXD when normal communication to other devices connected TXD, so if you want to receive data transmitted by its own name suggests , it is their own to receive data transmitted , which is directly connected to its own TXD RXD, used to send and receive test itself is normal, is the quickest and easiest test method, when a problem first do the test to determine whether a product failure. Also known as the loopback test .
AT command baud rate configuration
AT command pro-test the following two: 1,2,3 command to send commands do not like any other character ( 0, n, r for a class)
First, the default parameters: Slave, 9600, N, 8,1. Passcode: 1234.
Second, AT command set as follows:
1. Test communications
Send: AT (return OK, one second left and right once)
2. change the Bluetooth serial port baud rate
Send: AT + BAUD2
Return immediately after changing the baud rate, and then to change the baud rate of the communication is necessary.
3. Change the Bluetooth name
Send: AT + NAMEname
4. Change the Bluetooth passkey
Send: AT + PIN0000